Campaign Troubleshooting
Fix the common campaign problems: no calls going out, failed contacts, wrong language, missing recordings and results not reaching your systems.
Showing instructions for Xebit VoiceCloud.Showing instructions for Xebit VoiceKit, on your own infrastructure. Switch with the selector at the top. Updated 22 October 2026.
Most campaign problems come down to one of four things: the campaign is not running inside a calling window, the list has bad numbers, the carrier or trunk is refusing calls, or capacity has run out. Work through the section that matches what you see.
The campaign is not placing calls
- Check the campaign is running, not paused or stopped.
- Check the time against the calling windows. Calls only go out inside them, in the time zone you set.
- Check the campaign has contacts left to call, and an outbound agent attached.
- Check your carrier and trunk: the trunk is registered, the outbound route is allowed, and the numbers you call from are active. See Carrier and SIP Issues.
- Check your minutes. On Xebit VoiceCloud, campaign calls draw on your monthly minutes commitment; if it is used up, add a top up of 5,000 minutes or wait for the next month. Unused minutes do not carry over.
- Check capacity. On Xebit VoiceKit, the number of calls you can run is set by your deployment and licence band. If you are at the limit, new calls wait until others finish.
Contacts show as not reached or failed
- Check numbers are in E.164 format with the country code, for example
+919876543210, not9876543210. - Try a failing number by hand from the same trunk to see whether it is reachable.
- Look at the call's details for the reason the carrier gave (busy, rejected, unreachable). A pattern of rejections usually means a carrier or trunk setting, not the list.
- Remove duplicates and import the list again.
Calls show the wrong number
The caller ID a person sees is set by your carrier and SIP trunk, not by Xebit. Check which trunk number the campaign uses and ask your carrier to confirm what they present.
The agent speaks the wrong language
- Check the language column on the contact, if you use one.
- Check the agent's language settings. See Configure an Agent.
- For people who mix languages, such as Hindi and English, say so in the agent's instructions. See Language Issues.
A recording or transcript is missing
- Find the call by date or number in the calls list and open its details.
- If the call was never answered, there is no conversation to record.
- Check the call is still inside the period in our data retention policy.
- Check your storage is healthy and the call is inside the retention period your deployment sets.
Contacts did not import correctly
- Check the name and phone number columns are present and matched to the right fields.
- Check every number has its country code.
- Remove blank rows and extra spaces, then import again.
- If contacts come from Zoho or Salesforce, check the connection is active and the right records are selected.
Results are not reaching your systems
- Check at least one call has finished; results are sent as calls complete.
- For webhooks, check the endpoint is reachable and returning success. See Webhook Failures.
- For Zoho or Salesforce, check the connection is active and reconnect it if it has lapsed. See CRM Sync Errors.
- On an air gapped install, the receiving system must be inside the network.
The campaign status looks stuck
- Refresh the page and wait a few minutes; counts update as calls finish.
- Check Observability for the campaign's progress, retries and pacing, and for any open incident.
Still stuck
Write to hello@xebit.ai or use the contact page, with the campaign name and an example call.
Support is included in your Xebit VoiceKit licence.
Next steps
- Run a Campaign: back to your campaign.
- Import Contacts: fix the list.
- FAQ: other common questions.